4260733011/ 4260706011/ TPMS Sensor 315Mhz for Toyota Matrix 2007|2008|2009|2010|2011|2012|2013|2014 PMV-107J

23.00$35.00$ (-34%)

In stock

  Message to supplier
SKU: PMV-107JMatrix2007|2008|2009|2010|2011|2012|2013|2014 Category:

Product name:TPMS Sensor for Vehicles

Refference Model: Toyota Matrix 2007|2008|2009|2010|2011|2012|2013|2014 N/A

Frequency: 315Mhz

OE Part Number: 4260733011/
4260706011/ PMV-107J

Relearn process:

NOTE: Not all Models came equipped with a TPMS reset button. If no button is found, then a relearn is not required following an
air pressure adjustment, tire rotation, or tire replacement. This button is commonly located on the driver’s side knee bolster,
inside the glove compartment, under the steering wheel, or next to the DLC/OBDII. The purpose of this button is to set a base-line
for the air pressure and re-establish communication between the sensors and the vehicle.
Initialization following rotation and tire replacement:
1. Inflate all tires to pressure listed on tire placard.
2. Turn ignition to ON/RUN position (engine off).
3. Hold down tire pressure reset button (located on instrument panel, knee bolster, or inside glove box) until TPMS telltale flashed
3 times.
4. Initialization will be completed when ECU has received signals from all sensors. Process may take 2-3 minutes.
5. If initialization is not complete, drive vehicle for approximately 20 minutes.
Initialization following new sensor installation:
1. A properly formatted scan tool is required to learn new sensor IDs when replacing sensors. After IDs have been registered via
the OBD, leave ignition on, and activate all sensors using TPMS activation tool.
TIA troubleshooting tip: Many Toyota SUV’s and Minivans have a Main / 2nd Switch commonly located inside or under the glove
box, or at the base of the knee bolster. (See image below) This switch allows the vehicle to store two sets of TPMS ID’s. One set for
Spring / Summer wheels / tires and a second set for Fall / Winter. When the button is not pressed, the system is monitoring the OEM
or “main” IDs on the vehicle. When pressed, the vehicle can then monitor a second set of IDs that can be stored for winter
wheels/tires. If the button is pressed and no IDs are entered under the second position, then the MIL will illuminate. So ensure the
you are writing the sensor IDs to the correct position.

Shipping Policy

(សូមចរចារជាមួយអ្នកផ្គត់ផ្គង់មុនពេលបញ្ជាទិញ)

(Please negotiate with supplier before order)

Refund Policy

(សូមចរចារជាមួយអ្នកផ្គត់ផ្គង់មុនពេលបញ្ជាទិញ)

(Please negotiate with supplier before order)

Cancellation / Return / Exchange Policy

(សូមចរចារជាមួយអ្នកផ្គត់ផ្គង់មុនពេលបញ្ជាទិញ)

(Please negotiate with supplier before order)


General Inquiries

There are no inquiries yet.

Main Menu